Premier SOL 2B Soluble Cutting Fluid
A low odour general purpose soluble cutting oil suitable for a multitude of applications around machine tool / engineering workshops.
Forms a good stable milky emulsion, even in hard waters up to 400 ppm Ca CO3 hardness. Good inhibition against corrosion of a wide range of ferrous metals, giving protection to workpiece and machine parts. Also good resistance to contact corrosion, so workpieces may be stacked without staining taking place. Low staining potential on many non-ferrous metals including copper and its alloys, also aluminium and its alloys. The product is both nitrite-free and contains only solvent refined mineral oils, thus keeping potential health and safety problems to a minimum. Contains a highly effective biocide to protect the emulsions in use.
Use coolant mixing valves where possible. When mixing by hand slowly add concentrate to water whilst stirring vigorously. Coolants should not be mixed in the machine sump. Avoid using chilled water.
Technical Data
|
pH (25 : 1 dilution ): |
9.3 |
|
Specific Gravity @ 15ºC: |
0.90 |
|
IP 125 Herbert corrosion test: |
40:1 no rust |
|
IP 287 Breakpoint corrosion: |
25:1 |
Recommended User Dilution
|
Turning, milling, sawing: |
30:1 |
|
Drilling, screw cutting, tapping: |
10:1 |
Coolant
